Fig. 10
8
5.
Thread the three pinion shaft handles (H) Fig. 8, into
the three holes located in the pinion shaft (J) as shown.
Fig. 8
J
H
H
Fig. 9
K
L
M
6.
IMPORTANT:
Make certain the spindle taper (K) Fig.
9, and tapered hole in chuck (L) are clean and free of any
grease, lacquer or rust preventive coatings.
NOTE:
Household oven cleaner can effectively remove any sub-
stance from the spindle and chuck; however, carefully
follow the manufacturer's safety rules concerning its
use.
7.
IMPORTANT:
Open the chuck jaws as wide as
possible by turning the chuck sleeve (M) Fig. 10.
8.
Holding chuck on taper of spindle, tap with a soft tip
hammer (N) or a block of wood and hammer to set
chuck, as shown in Fig. 10.
IMPORTANT:
To avoid
damage to the chuck,
NEVER
drive the chuck onto the
spindle with a metal hammer.
M
N
Summary of Contents for ShopMaster DP115
Page 15: ...15 NOTES ...
Page 16: ...16 NOTES ...
