9
Quick installation guide for RPI H3 inverters EU EN 5013227802 02 2016-01-05
1.
Turn the DC disconnection switch to position
OFF
.
2.
Remove the cable sheath as shown and remove
12 mm of
insulation from each wire end. Do not twist wire ends as this
reduces the surface contact area with the wire end sleeve
(bootlace pin).
12 mm
52.5 mm
12 mm
55 mm (PE)
3.
Place a wire end sleeve on each wire end and crimp them on
tightly.
4.
Connect the AC cable to the AC plug as described below.
►
Unscrew the cable nut from the cable housing.
► Remove the cable housing with a 3.5 mm lat end screw
-
driver.
3
.5
mm
►
Slide cable nut and cable housing onto the AC cable in the
given order.
►
Slide the wires of the AC Cable into the connections in the
socket insert and screw them tightly (typical torque 0.8 to
1.0 Nm). Observe the correct phase sequence when wiring
the AC plug.
N
L
= PE
