LTL3000 User Manual / June 2020
22
DELTA
For your safety
Read all instructions. Failure to follow all instructions listed below may result in electrical shock, fire and/or
serious injury.
•
The battery and the charger are specifically designed for use in conjunction with one another.
Charging should be done only with the charger delivered with the instrument.
•
Protect the battery from rain and moisture. The penetration of water in a battery charger increases
the risk of electric shock.
•
Do not insert battery pack in charger if battery is cracked. Using damaged battery may result in
electric shock or fire.
•
Do not disassemble charger or operate the charger if it has received a sharp blow, been dropped or
otherwise damaged in anyway. Incorrect reassembly or damage may result in electric shock or fire.
•
Keep the battery charger clean. Contamination may cause the danger of electric shock.
•
Check the battery charger, cable and plug each time before using. Do not use the battery charger
when defects are detected. Do not open the battery charger yourself and have it repaired only by
qualified personnel using original spare parts. Damaged battery chargers, cables and plugs increase
the risk of electric shock.
•
Do not operate the battery charger on easily inflammable surfaces (e.g. paper, textiles, etc.) or
combustible environments. There is danger of fire due to the heating of the battery charger during
charging.
•
Do not store battery in charger. Storing the battery in the charger over a long period of time could
lead to battery damage and fire.
•
See further details in the charger user guide.
Practical advice
With continuous or repetitive charging cycles without interruption, the charger can warm up. This is of no
consideration and does not indicate a technical defect of the unit.
USB connection
The LTL3000 is featured with an USB port for connection to a USB memory stick, when you want to transfer
measurement data. The USB port is placed on the side of the instrument above the battery slot.
Only use a FAT32-formated USB memory stick. Other file formats are not supported. If your USB stick is not
working, reformat it and select
‘FAT32’ as file system.
