7URXEOHVKRRWLQJ
Chapter
7
Chapter 7 : Troubleshooting
Q1. How to set up a SNTP server on my workstation for the SNMP IPv6 to syn-
chronize?
To enable SNTP services in Windows XP, go to
Start
Ȼ
Control Panel
Ȼ
Add/
Remove Programs
Ȼ
Add/ Remove Windows Components
Ȼ
Networking
Services
Ȼ
check
Simple TCP/ IP Services
Ȼ
OK
. To enable time synchroni-
zation, you need to set SNTP time server addresses in
Time Server
. Please refer
to
Chapter 4: System Configurations
.
Q2. How to make sure that network connection is established between my
workstation and the SNMP IPv6?
To check connection between the SNMP IPv6 and workstation, in Windows
please launch DOS prompt mode (
Start
Ȼ
Run
Ȼ
key in
cmd
and press
En-
ter
). In Linux, launch Shell. Enter the following command:
ping Host Name
(default: InsightPower). If the connection is correctly established, you should
be able to receive replies from the SNMP IPv6.
&?!SLQJ
3LQJLQJZLWKE\WHVRIGDWD
5HSO\IURPE\WHV WLPH PV77/
5HSO\IURPE\WHV WLPH PV77/
5HSO\IURPE\WHV WLPH PV77/
5HSO\IURPE\WHV WLPH PV77/
3LQJVWDWLVWLFVIRU
3DFNHWV6HQW 5HFHLYHG /RVW ORVV
$SSUR[LPDWHURXQGWULSWLPHVLQPLOOLVHFRQGV
0LQLPXP PV0D[LPXP PV$YHUDJH PV
&?!
Q3. I can access the login page, but cannot log in the InsightPower UPS Web.
Please check the IP addresses of the SNMP IPv6 and the workstation you are
trying to log in. The cause could be they are not connected to the same LAN.
In that case, launch
EzSetting
and change
User Limitation
settings to
Allow
Any
. Please see the following figure.
Summary of Contents for InsightPower SNMP IPv6 for UPS
