Delta HDMP_S100, User Manual

Page: 5 / 110

English-3
English
Warning:
1. The main power switch must be off and the power cord must be detached before
installation of the expansion module.
2. Do not pull out the expansion module when the display is in use, doing so may result
in damaging the expansion module and the display monitor permanently.
3. Installation of the expansion module must be done by a qualified technician and don't
touch these pin inside black connector to prevent ESD.
After installing the HDMP-S100 expansion module to the display, please follow the
instructions in the User’s Manual for setting up digital signage content management
services software resided in the module.
Power Up Messages
After turning on the display with the HDMP-S100 module installed, you should see the
following message appeared on the screen,
1. Startup logo on screen.
2. In a few seconds, you should see additional text information showing of the screen,
a. MAC address (unique network identifier of the HDMP-S100)
b. DHCP status (“NO DHCP” if DHCP service is not found)
c. IP address assigned by DHCP service (“169.254.1.1” if no DHCP service is
found)
d. Operation mode: LAN or WAN (Local Area Network or Wide Area Network)
mode. The factory default is set to WAN mode. Please follow the instructions if
other mode of operation is desired.
3. If you are in WAN mode, the Digital Signage Player will try to reach out and connect to
a designated server.