Delta DVPPS01, Instruction Sheet

Page: 3 / 4

Y
Electrical Specifications
Model
Item
DVPPS01 DVPPS02 DVPPS05
Power input 100 ~ 240VAC (-15% ~ +10%), 50/60Hz
Output power 24VDC (±3%)
Maximum output current 1 A 2 A 5 A
Ripple & noise
Under 100mV
p-p
Typical at
full load
Under 240mV
p-p
Typical at full load
Efficiency 78% ~ 87% Typical at full load Above 88% Typical at full load
Overcurrent/short circuit
protection
Auto Recovery
Overvoltage/
overtemperature
protection
--
Overvoltage protection: The
power supply is cut off for 5
seconds. DVPPS05 operates
normally after power is
supplied.
Overtemperature protection:
The power supply is cut off for
5 seconds, and the
temperature inside DVPPS05
falls to the temperature below
85
o
C. DVPPS05 operates
normally after power is
supplied.
Grounding
The diameter of grounding wire cannot be smaller than the wire diameter of terminals L and
N (All PLC units should be grounded directly to the ground pole).
Operation environment
0°C~55°C (temperature), 50~95% (humidity), Pollution
degree 2
-20°C~55°C (temperature),
50~95% (humidity),
Pollution degree 2
Storage environment -25°C~70°C (temperature), 5~95% (humidity)
UL UL508 Listed (Industrial Control Equipment)
Agency
approvals
CE
European Community EMC
Directive 89/336/EEC and
Low Voltage Directive
73/23/EEC
EMC Directive 2004/108/EC and Low Voltage Directive
2006/95/EC
Weight (g) 158 250 488
Z
Installation and Wiring
ƒ
Mounting Arrangements and Wiring
DIN Rail Installation:
The DVPPS can be secured to a cabinet by using the DIN rail
that is 35mm high with a depth of 7.5mm. When mounting the
DVPPS on the DIN rail, be sure to use the end bracket to stop
any side-to-side motion of the DVPPS, thus to reduce the
chance of the wires being pulled loose. On the bottom of the
DVPPS is a small retaining clip. To secure the DVPPS to the
DIN rail, place it onto the rail and gently push up on the clip. To
remove it, pull down on the retaining clip and gently pull the
DVPPS away from the DIN rail. Please see the figure on the
right:
For heat dissipation. Make
sure to provide a minimum
clearance of 50mm between
the unit and all sides of the
cabinet. (as shown below)
Direct mounting: Tighten M4 screws into direct mount hole.