BATTERY STRENGTH INDICATOR
To check the battery strength:
Press and hold MODE (yellow pushbutton on left hand side). After 5 seconds the battery strength will be displayed:
Ɣ
FUL - Healthy
Ɣ
MID - Average
Ɣ
Lo_ - Low Average
Ɣ
bAd - Replace Batteries (buzzer will annunciate and LED will blink if activated - if these features are turned on)
Page 5
208623 Rev. B
w w w . s p e c s e l e c t . c o m
To adjust settings, press and hold MODE (yellow pushbutton on left hand side) until the Function symbol appears. Once in Adjust-
ment Mode, keep pressing MODE until desired Function is reached (see Quick Reference Table). To change Function Setting,
press and release TOGGLE (white pushbutton on right hand side) until desired Function Setting is reached (see Quick Reference
Table).
Note:
Controller will leave Adjustment Mode after 5 seconds of inactivity.
SENSOR SENSITIVITY (d)
Higher numbers represent a more sensitive configuration. Higher sensitivitiy will increase the distance at which the user is detected.
The sensitivity settings are on a 10 point scale (1 - 10). Please note that these setting values are relative values and do not
correspond to a particular distance.
AUTO TIMER (T)
Auto Timer is a safety mode in the event the sensor continually senses a target. In this case, the faucet will stop after the pre-
determined time period expires.
RINSE CYCLE (R)
This feature is meant to purge stagnant water from supply lines. The faucet will turn on after the set amount of hours of inactivity
and run the set
Rinse Time (r)
(see below).
RINSE TIME (r)
This feature is only active if a
Rinse Cycle (R)
time is chosen. The setting determines for how long the faucet will turn on during the
Rinse Cycle (R)
.
BUZZER (b)
For Proximity the buzzer setting does not silence the controller and sensor status annunciations.
Buzzer options are ON and -(OFF), the default setting is ON.
METERING MODE (M)
This feature changes the product into a metering faucet; it will run the full set amount of time after the user’s hands are first detected.
Note: Auto Timer (T)
is disabled when the feature is turned on.
Function
Function
Setting
MODE
TOGGLE
If you have any questions about the installation of this product or need help troubleshooting this product, please call Delta
Commercial Technical Services at
1-800-387-8277.
