9
Fig. 19
Fig. 20
Fig. 21
Fig. 22
ASSEMBLING INTAKE PORT
TO MOTOR AND BLOWER
ASSEMBLY
Place the intake port (A) Fig. 19, onto the flange of
motor/blower assembly (B). Align the holes in the flange
(B) of the motor/blower assembly with the mounting
holes in the dust intake port and fasten with four sheet
metal screws (C) as shown in Fig. 20.
WARNING:
The blower housing contains a high speed radial
blade that can amputate fingers, grab loose clothing
and neckties, or propel dust at high speeds.
WARNING: NEVER INSERT FINGERS OR ANY
FOREIGN MATTER INTO THE DUST INTAKE PORTS.
ASSEMBLING BAG
SUPPORTS, BAG HANGERS,
AND FILTER BAGS TO
DRUMS
1.
Assemble bottom half of threaded lower bag
support (A) Fig. 21, to center of drum assembly (B).
Place a 5/16" lockwasher on a 5/16-18 x 1¼" hex head
screw (C), insert screw (C) up through the bottom of
drum (B), and place special washer (E) (51½mm O.D.
9.8mm I.D. 4mm thick), onto the screw that was inserted
through drum (B). Thread screw (C) into lower bag
support (A) and tighten securely. Bottom half of lower
bag support can be identified by the protrusion “pin” (F)
in the support. Repeat this process for the other drum
assembly.
2.
Fig. 22, illustrates the lower bag support assembled
to the drum assembly.
C
B
A
F
A
B
E
D
C