Delta OHM HD32.2, Manual

Page: 35 / 52

- - 35
12. Using Browse , indicate the installation folder provided at point 5:
C:\Programmi\Texas Instruments\USB-Serial Adapter
Confirm with OK .
13. If you get the message that the software did not pass the Windows Logo testing, select “ Con-
tinue ”.
14. The USB driver is installed: At the end, click on “ Finish ”.
15. The installation program requests the files location once more : Repeat the just described
steps and provide the location of the same folder (see point 12).
16. Wait : The operation could take a few minutes.
17. The installation procedure is now complete: The device will be detected on each new connec-
tion automatically.
In order to check if the entire operation was successful, in CONTROL PANEL double click on
SYSTEM. Select "Device Manager" and connect the instrument to the USB port.
The following items should appear:
“In order to check if the entire operation was successful, in CONTROL PANEL double click on
SYSTEM. Select "Device Manager" and connect the instrument to the USB port.
The following items should appear:
•
“ UMP Devices >> UMP3410 Unitary driver ” and “ Porte (COM and LPT) >> UMP3410
Serial Port (COM#) ” for Windows 98 and Windows Me,
•
“ Schede seriali Multiport >> TUSB3410 Device ” and “ Porte (COM and LPT) >> USB-
Serial Port (COM#) ” for Windows 2000, NT and XP.
When the USB cable is disconnected, these two items disappear and come back when it is con-
nected again.
Notes.
1. If the instrument is connected to the USB port before installing the drivers, Windows signals the
presence of an unknown device: In this case, cancel the operation and repeat the procedure illus-
trated at the beginning of this paragraph.
2.
In the documentation supplied with the DeltaLog10 CD-Rom , is included a detailed version
of this chapter with pictures. Moreover, the necessary steps to remove the USB drivers are re-
ported.