Delta OHM HD2107.1, Operating Manual

Page: 20 / 38

HD2107
- 20 -
V2.3
The following table reports the indications provided by the instrument as they appear on the display,
together with their description.
Display indications Explanation
>>> CAL_MODE >>> KEY_UNIT
FOR_NEW_USER CAL_
calibration mode >>> press UNIT to start a new user calibration
>>>_LOG_DUMP_or_ERAS
transfer or erase data
>>>_PRBE_TYPE
type of probe connected
1ST_MEAS UP DOWN
correct the first point using the arrows /
2ND_MEAS UP DOWN
correct the second point using the arrows /
BATT TOO LOW - CHNG NOW battery discharged - replace it immediately
BAUDRATE >>> baud rate value
CAL FACT factory calibration
CAL USER user calibration
COMM STOP printing complete
COMM STRT printing started
DAY_ day
DUMP_END data transfer complete
DUMP_In_PROG >>> data transfer in progress
ERR error
FUNC CLR
max, min and average values clearing
FUNC CLRD
max, min and average values cleared
HOUR
hour
LOG In PROG
logging in progress
LOG MEM FULL
memory full
LOG_CLRD memory data cleared
LOG_STOP logging complete
LOG_STRT logging started
MIN >>> USE_UNIT_TO_ZERO SEC minutes >>> use the UNIT key to reset the seconds
MNTH month
NEW_PROB_DET new probe detected
NO_PRBE_ SER_NUM the connected probe's serial number is absent
nonE no selection
OVER maximum limit exceeded
PLS_EXIT >>> FUNC RES_FOR_FACT
ONLY please exit using FUNC >>> function reserved to factory calibra-
tion
PRBE_SER #### #### serial number #### #### of the connected probe
PRNT AND LOG INTV printing and logging intervals
PRNT INTV >>> printing interval
PROB COMM LOST
lost communication with probe
PROB ERR
probe error
SEL MEAS 1/2
select measurement 1 or 2
SLP_MODE_LOG
turning off during recording mode
SYS ERR #
program error number #
UNDR minimum limit exceeded
YEAR year