EN
4
5
Recommendations
- Correct operation of the motor is ensured if it is installed and used
according to the following recommendations.
It is essential that peripheral components such as the rolling tube,
the supports, the screws etc. are appropriate and are assembled
in accordance with the latest standards. The specifications of the
driven part must be compatible with the assigned load and operating
time.
- Weighted noise pressure level A: LpA ≤ 70 dB(A).
- Cables passing through a metallic wall must be protected and
isolated by a sleeve.
- If the power cable is damaged, the motor must be replaced by the
manufacturer, by the aftersales service, or by similar qualified
personnel, so as to avoid any danger.
- The motor must be chosen according to the requirements of the load
bearing support. See our charts regarding the selection of the motor
according to shutter type. A plate on the motor indicates the nominal
torque and operating time.
- TYMOOV xFB tubular motors are designed to operate
intermittently (4 minutes of continuous operation). They are
electronically protected to prevent overheating. If there is a thermal
shutdown, the motor will operate again after a timeout period of
around 20 minutes. To operate again for a period of 4 minutes, the
motor must have returned to room temperature.
DELTA DORE hereby declares that the motorised drive unit covered by these
instructions is compliant with the essential requirements of the Machinery
Directive 2006/42/EC, and the European directive RED 2014/53/EU
The EU declaration regarding this device is available on request,
with requests to be submitted to the following address:
«Technical info» department
DELTA DORE – 35270 Bonnemain (France)
Email: [email protected]
DELTA DORE
35270 - BONNEMAIN - France
Because of changes in standards and equipment, the characteristics specified in the text and illustrations
in this document are not binding unless confirmed by our respective departments.
