EN
12
13
3/ Setting stops
3.1 Adjusting screw selection table
Interior winding
Exterior winding
Left mounted
motor
Right mounted
motor
Left mounted
motor
Right mounted
motor
Setting the top
stop
Red adjusting
screw
White adjusting
screw
White adjusting
screw
Red adjusting
screw
Setting hte
bottom stop
White adjusting
screw
Red adjusting
screw
Red adjusting
screw
White adjusting
screw
3.2 Setting the bottom stop
The skirt of the roller shutter must be detached from the winding spindle.
❶
Activate the motor to lower the shutter until its reaches its stop.
❷
While still holding the control to lower the shutter, turn the bottom stop (see
table) adjusting screw towards (+) until it reaches the correct position for the
securing of the lock.
❸
Attach the roller shutter to the tube using the locks.
3.3 Setting the top stop
❶
Activate the motor to raise the shutter.
❷
NOTE: if the shutter reaches the stop before the motor stops, switch it off
immediately.
In the opposite case (if the motor stops before reaching the top stop),
move on to step
❻
.
❸
Turn the adjusting screw for the top stop (see table) in the (-) direction.
❹
By applying the control to lower the shutter, bring the roller shutter to beneath
the desired position, and stop it there.
❺
Repeat operations
❶
to
❹
until the shutter reaches the top stop (in this case,
move on to step
❻
).
❻
The motor stops beneath the top stop.
Holding down the control to raise the shutter, turn the top stop adjusting screw
towards (+) until the roller shutter reaches the desired position.
❼
The stops have been set.
If the motor is not working:
- Check that the wiring corresponds to the diagrams in the «Connection» chapter.
- Check the power supply within the network.
- Check that the motor is not in thermal protection mode; just wait 20 minutes for it
to cool down.
- Reset the end of travel positions if necessary.
The end of travel points are not adhered to:
- Check the mechanical components of the system
(stabilisation, play, distortion, etc.)
- Reset the end of travel positions if necessary.
Inversion of the direction of rotation.
- Switch the black and brown wires connecting the motor to the change-over switch.
4/ Troubleshooting
