5
HANGING YOUR FAN
WARNING
Do not attach the blades to the fan until it is
assembled and hanging from the ceiling. Doing so
beforehand will likely bend the blades and could
cause the fan to wobble.
1.
(Fig. 6) Remove the set pin and safety lock clip
from down-rod. Slide the down-rod through the
canopy, canopy cover, and coupling cover. Partially
loosen the down-rod set screws from coupling at
top of motor assembly. Thread lead wires from
motor assembly through down-rod.
2. (Fig. 7) Install down-rod into motor housing
coupling, aligning the holes and install set pin and
safety lock clip. Insert set pin through coupling
and down-rod until point appears on the other
side, and insert safety lock clip on set pin. Pull the
down-rod up tight against the set pin, and then
evenly tighten the down-rod set screws on motor
coupling. Place coupling cover on motor assembly.
Warning: set pin and safety lock clip must be
installed securely, failure to install them will result
in serious injury.
3.
Lift the fan motor without the blades and place
into the hanger bracket, rotating the ball until the
groove engages the tab on the hanger bracket.
This locks the ball mount and fan motor, preventing
fan rotation during operation. (Fig. 8)
Down-rod assembly
Safety lock clip
Ceiling canopy
Canopy cover
Coupling cover
Coupling
Set pin
Set screws
Set pin
Set screws
Safety lock clip
Hanger bracket
Downrod assembly
Groove
Tab
8
6
7
