43
PROFESSIONAL MODE:
PROGRAMMING CUSTOM FIRING PROGRAMS
You can enter up to 22 custom firing programs in the controller for all of your firing
needs. Each program can contain up to 8 steps (segments).
Special note: All changes made to both the pre-programmed and customer programs
will be permanently be stored in the memory until you change them!
Configuration
Pre-
Programmed
Custom
Programs
-90-
4
4
-96-
4
4
bEAd
4
4
CLA
5
4
Usr
0
6
During the programming, the display prompts for the individual firing programs are
Pr
followed by the program number like
Pr01
,
Pr02
,
Pr03
, etc.
To select any of the available programs it is first necessary to be in the
IdLE
mode.
1. Press (Program) button and the last used program will be the first to come up.
2. Press (Increase) button to select the program you would like to enter or change.
3. Press (Program) button again when the display shows the firing program you
want.
4. Press (Program) button to begin programming your firing schedule. The display
will first prompt
rA 1
for the rate of the first segment in your program.
5.
Press (Increase) or (Decrease) button to change the firing rate. If you‟d like the
rate to be as fast as possible, press the (Decrease) button until the display
changes to
0
, then press the (Decrease) button one more time and display will
change to
FULL
.
6. Press (Program) button to proceed to the set point temperature. The display will
prompt
°F 1.
7. Press (Increase) or (Decrease) button to change the set point temperature.
8. Press (Program) button to proceed to the hold time. The display will prompt
HLd1.
9. Press (Increase) or (Decrease) button to change the hold time. Hold time is
entered in Hours and Minutes. For example, a 1 hour hold time should be
entered as 01.00, and a 30 minute hold will read 00.30.
10. To add additional segments, repeat steps 4-9.