Document Title:
BI-NEU RTM Homologation Description
Page 5 / 5
2.3.2 Variants
The EUT only supports one configuration setting
$DE00 = 0x1
2.4
EUT Samples & Configuration
One unmodified sample, one receive test sample for low band reception (315MHz), one receive test sample for
high band reception (903MHz) and eight transmit test samples were provided to the homologation vendor for
certification testing and approval in the countries defined in the statement of work.
2.4.1 Functional Configuration/Operation Modifications
The samples provided for certification testing were modified/programmed by the manufacturer based on the
following:
2 receive test samples provided for certification testing runs in polling mode whenever 8V to 16V
(12.8V) is applied to the power supply input pin and were modified by the manufacturer in order to
indicate a correct received frame with a LED at the LIN output of the module to see if the module is still
in polling mode and able to receive telegrams.
4 samples (one for each channel / antenna combination) have special SW in order to transmit a
continuous carrier to conduct the Transmit certification testing.
4 samples (one for each channel / antenna combination) have special SW in order to transmit
continuously an ACK frame to conduct the Transmit certification testing.
2.4.2 Production Intent
The samples provided for certification testing are ready for production and were produced via the production
intent processes.
„
NOTICE:
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by (manufacturer name) may void the
FCC authorization to operate this equipment.
”
