5
INTRODUCTION
Thank you for choosing a De’Longhi product. Please take a few
moments to read the instructions to avoid risks or damage to the
appliance.
DESCRIPTION
Description of the appliance (see page 3 - A)
A1
air outlet grille
A2
control panel
A3
handles
A4
castor wheels
A5
BioSilver filter
A6
air intake grille
A7
air exhaust hose housing
A8
air intake grille
A9
power cable
A10
drainage hose with 2 caps
A11
remote control signal receiver
A12
remote control compartment
Descrizione of the accessories (see page 3 - B)
B1
wall flange with cap
B2
air exhaust hose
B3
hose adaptor
B4
accessory for wall mounting
B5
window bracket with pins
B6
additional window bracket
B7
window outlet
B8
remote control
B9
end of season dust cover
B10
end of season accessories bag
Electrical connection
Before plugging the appliance into the the electrical receptacle,
check that:
• The outlet’s power supply corresponds to the value indi-
cated on the rating label on the back of the appliance;
• The outlet and electrical circuit are adequate for the appli-
ance;
• The outlet is a 3-hole grounded outlet
. If this is not
the case, you must choose another outlet. Failure to follow
these important safety instructions absolves the manufac-
turer of all liability.
If it becomes necessary, the power cable must be re-
placed by a qualified professional only.
The instructions below will enable you to prepare your air con-
ditioner for operation as efficiently as possible. Before use, make
sure the air intake and outlet grilles are unobstructed.
USE
AIR CONDITIONING WITHOUT INSTALLATION
For optimal results set-up in a double-hung window:
1) Place the bracket in the window sill, extend the bracket
fully within the window frame, fix the bracket by using the
pin then lower the window onto the bracket, (should the
window bracket be too large for the window. The plastic
can be cut with a saw by a qualified professional.)
2) Screw the hose adaptor
B3
to the hose’s end
B2
.
3) Fit the air exhaust hose in the housing at the back of the
appliance. Insert it as shown in figure 1.
4) Connect the window outlet
B7
to the other end of the ex-
haust hose.
5) Insert the window outlet end of the exhaust hose into the
slot of the window bracket (fig. 2).
Other set-up methods:
• Thanks to the locking pins, it’s possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust hose
(see figure 3).
1
2
