24
8) Regulating of the oven minimum
To be effected only for the oven burner (as the grill burner has an only fixed input) operating
on the thermostat as follows:
– Light the oven taking the knob to position 230
– remove the knob and by a thin screwdriver (3 mm section - 100 mm long) unscrew of
about a half turn the by-pass, passing through the front panel hole (see picture below)
– fit the knob and let the oven heat for 10 minutes, then take the knob to position 130
allowing the thermostat to work under by-pass G (fig. 26).
– after further removal of the knob, stop slowly the screw by-pass (being careful not to turn
the knob) until the flame reaches 3-4 mm high.
N.B. For LPG the by-pass screw must be fixed thoroughly.
Fig. 26
G
