19
Conversion to LPG
Fig. 18
M
J
A
2 - Adjusting of primary air
of the top burners
By operating the screw “
M
”, reset the air
adjuster “
A
” according to the instructions
see “Injector table”, where the distance
between injector and air adjuster is
recommended (in mm).
Before lowering the hob top, set the
burners on their sites and light them in
order to check whether the flames are
correct, as per the specifications given in
the next page. In case of uncorrect flame,
lift or lower the air adjuster.
1 - Injectors replacement of top burners
To replace the injectors it is necessary to lift the cooktop and proceed as follows:
– Unscrew the two screws “
B
” and remove the hinge sockets.
– Remove pan-supports and burners from the cooktop.
– Pull forwards the cooktop to release it, then lift following arrow “
D
” (Fig. 16)
– Hold the cooktop open by a support (Fig. 17).
– Fully raise the adjusting air tube A (fig. 18) in order to easily reach the injector.
– By an angle 7 spanner, remove the injector from their housing and replace it by the proper
one according to the kind of gas (see following tables - page 21).
Fig. 17
B
B
D
Fig. 16
