OPERATING INSTRUCTIONS
Operation
• Plug the appliance into the power outlet.
• Press the ON/OFF button A to switch on the
appliance (the button will light up) The
appliance will start at maximum power.
At this point, the appliance is ready to
vacuum.
Electronic suction power adjustment
After having pressed the ON/OFF button, to
change the suction power use the 2 buttons
B
and
C (+ or -), adapting the power to the type of
surface being cleaned.
In this way, the maximum power (+) of the
appliance can be used when vacuuming dust from
carpets or hard floors (marble, ceramics,
terracotta etc.) or reduced suction power (-) can
be used when cleaning curtains and other
light/delicate fabrics.
Mechanical suction power adjustment
The handgrip on the hose is fitted with a
mechanical suction power control, allowing the
power to be varied quickly and practically by
simply moving the slide (Fig. 7).
AIR PURIFICATION
This function allows the ambient air to be purified.
The air sucked into the appliance is completely
purified by the water and the other filtering
stages, and is then discharged into the
environment.
To activate this function, fill the tank with around
2.5/4 litres of water, and after having plugged
the appliance into the outlet, press the purification
button
D
. The corresponding button will light up.
The appliance can also be used as an aroma
diffuser. To do this, simply pour a few drops of the
required fragrance into the water in the tank, and
proceed as described above.
Note: To use the appliance as a purifier, remove
the hose
G
and replace with the intake nozzle
X
supplied.
The appliance can also be operated in this mode
without the trolley, by simply resting the tank on
an even surface.
"AUTOCLEAN" FUNCTION (WF1400ES
models only)
This function is used to automatically clean the
tank.
To activate this function, empty the dirty water out
of the tank and then fill it with around 4 litres of
clean water and 20 cc (equal to 3 capfuls) of
shampoo (Z1). Plug the appliance in and then
press button D for at least 4 seconds. This starts
the "AUTOCLEAN" function (the LEDs will
continue to flash while the function is active): after
around 15 minutes, stop the function by pressing
the ON/OFF button A. At the end of the
operation, empty the tank, shaking it to remove
even the most difficult dirt. Rinse the foam filter.
CLEANING AND MAINTENANCE
Caution: Always disconnect the appliance from
the mains outlet before performing any cleaning
or maintenance operations.
After the appliance has been used, to ensure
maximum hygiene, the accessories should be
rinsed by vacuuming up clean water. This will
clean the accessories and the inside of the hose.
Always empty out the wet-dry tank after use.
After emptying and rinsing the tank, remove the
foam filter, wash it under running water and let it
dry completely before re-positioning. Periodically
check that the float is free to move (Fig. 8).
The filter must be kept dry to prolong its life.
15
fig. 7
fig. 8
A
B
C
D
+
-
