DeLonghi TRRS0920E.G, Manual

Page: 12 / 14

11 7
remains on. When the programmed time has elapsed, the
appliance will come on with the previous settings.
Delayed stop: with the appliance on, press the timer
button . The hours left before the appliance goes to
stand-by mode, the power level and in case the function
selected are displayed together with the symbol and "h"
symbol flashing (see fig. 3). Change the hours using the +
and - buttons, then wait a few seconds for the program to
be stored. The current settings and symbol are displayed.
At the end of the set time the appliance switches to standby
mode automatically. To go back to operating without the
timer, press the timer button twice. The timer symbol
disappears from the display.
Please note: the time is settable from 0.5 to 24 hours.
Change of the temperature scale
The display can show the temperature in both °F and °C.
To select the desired temperature scale, when the unit is in
standby position, press and hold the "+" and "ECO" keys for
at least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
Brightness of the display
The appliance allows two different brightness settings for the
display. The highest is active when any key button is pressed.
After a few seconds of key board inactivity, the brightness will
decrease to the operating brightness level. This lower level
can be adjusted in this way:
-
with the appliance in on mode after pressing for 5
seconds the ECO button the display will show (see fig.
4):
- With the + and - button is possible to select the desired
brightness (three brightness levels available).
- After 5 seconds without to press any button, the
brightness level will be memorized and the operating
conditions will be the same ones previously set.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
-
(Probe Failure) blinking
With this alarm the appliance does not operate. Contact
the De'Longhi Customer Service.
- (High temperature)
When the product’s internal temperature is too high,
the heating power will progressively and automatically
be reduced.
The display shows
for two seconds, blinking. To
remove the cause of this alarm check that the unit is not
covered and let the appliance cool down.
SAFETY DEVICE
A safety device switches the heater off in the event of
overheating.
To restart the heater, call the De'Longhi Customer Service.
MAINTENANCE
Always remove the plug from the power outlet and allow the
radiator to cool. Wipe radiator with a soft damp cloth, do not
use detergents and abrasives. Should the radiator not be in
use over a certain length of time, wind the cord around the
cord holder and store it in a dry place. This appliance has been
built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater
by yourself: this may result in a fire hazard or electric shock.
Call the De'Longhi Customer Service (see attached list of
De'Longhi Customer Service).
TECHNICAL CHARACTERISTICS
Supply voltage See rating plate
Absorbed power “
Fig. 3
Fig. 4