DeLonghi TRRS0920E.G, Manual

Page: 11 / 14

4 10
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface area
of less than 43 square feet (4 sq.m.).
Power connection
- Before using the appliance check that your supply
voltage is the same of that shown on the rating label
of the unit and that the power socket and power supply
line correspond to the load specified.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
Plug in the heater, the appliance will be set in the stand-by
condition. The display will show the
symbol. Keep loose
clothing or bedding, furniture and flammable material away
from the power outlet when the heater is plugged in. After an
interruption of the power supply (power failure or appliance
unplugged) the unit goes always to stand-by.
Heating function
To turn the appliance on, press the (B) button.
Press button
(E) to set the required power level:
MIN ( ); MED ( ); MAX ( ) (see fig. 2). To
select the desired temperature, press or - (C or D).
By pushing the + or - button once, the temperature (shown
on the display) will increase or decrease by 1°C. Keeping the
+ or - button depressed the value will increase o decrease
rapidly.
The appliance allows to set the temperature from 10° to 28°C.
Anti-freeze function
Setting the temperature to 5°C with the "-" button, the
appliance will activate the Antifreeze function.
The display will show the symbol, in this way the
appliance will turn on automatically, at the max power,
only if the room temperature falls below 5°C. If you wish to
go back to the Heating function, press the "+" button once.
After an interruption of the power supply (probe failure or
appliance unplugged) the unit goes always to stand-by.
Eco function
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
To activate this function press the "ECO" (F) button. The
display will show
symbol. If the selected temperature
is much higher than the actual room temperature, the
appliance will start automatically and rapidly to heat the
room.
The appliance will automatically select the most convenient
power level (
MAX-MED-MIN-OFF
).
If
MAX
power level has been selected using the
button, the appliance will cycle between: MAX-MED-MIN-
OFF.
If MED power level has been selected, the appliance will cycle
between:
MED-MIN-OFF.
If
MIN
power level has been selected, the appliance will cycle
between: MIN-OFF.
Working indicator
The symbol indicates the heating status by means of its
colors.
RED: the unit is heating at the maximum power.
ORANGE:
the unit is heating at the medium power.
GREEN: the unit is heating at the minimum power.
absent: the unit is not heating.
Key lock
In order to avoid accidental operation, you can lock the
keyboard using the keylock function. To activate this function
during on mode, press b and - together for at least
3 seconds. The display shows the symbol and a double
acoustic signal will be emitted. To disactivate the function
proceed in the same way.
Timer function
This function can be activated in two different ways.
Delayed start: With the appliance in standby mode, press
the timer button (G) . The hours left before the appliance
comes on is displayed together the symbol and "h"
symbol flashing (see fig. 3). Change the hours using the +
and - buttons, then wait a few seconds for the program to
be stored. The display will return to off and the symbols
Fig. 2
Fig. 1