11
The appliance operates at minimum power, automati-
cally reducing energy consumption and noise level. The
tones emitted by the commands are lower than in other
modes for even more silent operation.
-
Heating
The appliance operates at medium power.
-
Heating
The appliance operates at high power to heat the room
rapidly.
“
ECO plus” function
The
“
ECO plus” function is available in Heating 1, 2 and 3
modes only.
To activate the function, press the
“
ECO plus” button (
D
).
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
While the
“
ECO plus” function is active, the appliance may
switch automatically to a lower heating power than the one
displayed. This may happen a number of times in an hour.
- To distribute the air flow over a wider surface, press the
swing button (
F
)
. The appliance starts swinging to
the right and left. To stop the appliance in the desired
position, simply press the swing button (
F
) again.
- To turn the appliance off, press the ON/STAND-BY
button (
A
). The display may visualize a countdown for
about 6 seconds.
Please note:
Room temperature can be displayed in ei-
ther °C or °F. To change the unit of measurement for the tem-
perature, press the + button for a few seconds, then release.
Digital 24 h timer
This function can be activated from any operating mode.
Auto-start:
with the appliance in STAND-BY, press the timer
button (
E
) .
The symbol is displayed together with the time remain-
ing before the appliance comes on.
To adjust the timer, use the adjustment b and - (
B
),
then wait a few seconds for the setting to be memorised. The
stand-by light (
I
) is displayed together with the symbol,
indicating that the timer has been set.
When the programmed time is reached, the appliance comes
on with the settings used during the previous period of op-
eration.
Auto-off:
with the appliance on, press the timer button
(
E
). The symbol is displayed together with the time re-
maining before the appliance goes off.
To set the timer, use the adjustment b and - (
B
),
then wait a few seconds for the setting to be memorised.
The current settings are displayed again, together with the
symbol indicating that the timer has been set.
When the programmed time is reached, the appliance goes
off automatically. To go back to operation without the timer,
press the timer button (
E
) twice.
The timer symbol disappears from the display.
USING THE REMOTE CONTROL
The functions on the remote control are the same as those
on the appliance control panel. For a description of the func-
tions, see the “Operation and use” section on the previous
page.
Inserting or replacing the batteries
The remote control is powered
by a CR2032 lithium battery.
To operate the remote control,
pull and remove the plastic
strip under the battery cover.
To replace the batteries, re-
move the battery cover by slid-
ing it as shown in the figure.
When replacing the batteries,
make sure you respect the po-
larity (see figure 2).
Replace the cover as shown in the figure.
Old batteries are harmful to the environment and must be
removed and disposed of in compliance with current legis-
lation.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
- To clean the filter, remove the rear grille by pulling it
outwards (fig. 1).
Remove the dust filter which retains impurities in the air
drawn in from the room, blow on it lightly then replace
in the appliance.
- Never use abrasive powders or solvents to clean the ap-
pliance.
TECHNICAL CHARACTERISTICS
Supply voltage
See rating plate
Absorbed power
“
Fig. 2
