10
the cable around the base.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Do not use the appliance to dry laundry. Do not obstruct
the air intake and outlet grilles (danger of overheating).
- Do not use the appliance near walls, furniture, curtains,
etc.
Safety functions
-
Safety device:
the appliance is fitted with a safety
device which switches it off in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the mains socket for
a few minutes, remove the cause of overheating then
plug in again.
If the appliance doesn't work please contact the
De'Longhi Customer Service.
-
Tip over safety device:
a tip over safety device turns
the appliance off if it falls over or is positioned inappro-
priately in such a way as to jeopardise safety.
The appliance emits a beep and a dot flashes on the
display. The appliance resumes operation a few seconds
after being placed in an upright position again.
Disposing of the appliance
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
DESCRIPTION
(see fig. 1)
A
ON/STAND-BY button
B
+/- adjustment buttons
C
MODE button (selects the operating mode)
D “
ECO plus” button
E
Timer button
F
Swing button
G
Remote control receiver
H
Remote control
I
Indicator light
J
Air intake grille
K
Filter
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
Electrical connection
-
Before plugging the appliance into the mains socket,
check that the mains power supply corresponds to the
value indicated on the rating plate and that the mains
power supply is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/
EEC ON RADIO INTERFERENCE SUPPRESSION.
Mounting the base
- Fit the two parts of the base together, matching the
guide pins on the front with the recesses on the back
and snapping the two clips into place (fig. A and fig. B).
- Turn the appliance upside down and position the as-
sembled base on the appliance in order to couple the
two openings with the two tabs on the appliance,
tilting it as shown in figure C, consequently turn the
base down till the two frontal teeth snaps into position
(figure D).
- Assembly time: approx. 5 minutes.
- Optional screw
- Fasten the tower to the base using the screw provid-
ed to achieve extra stability (figure D).
-
Tools needed and estimated time:
1 Phillips head screwdriver type PH 2 x 100
1 screws (included)
Assembly time: approx. 2 minutes.
Operation and use
- Plug into the mains socket.
- The appliance emits a beep. The indicator light (
I
) comes
on and remains lit while the appliance is powered.
- The appliance switches to stand-by. A dot flashing on
the display means the tip over device has been activat-
ed. See paragraph: “Safety functions”.
- Press the ON/STAND-BY (
A
) to turn the appliance on. It
begins heating the room according to the current set-
tings.
- Press the MODE button (
C
) to select one of the following
operating modes:
-
Fan
In this mode, only the fan operates and the appliance
does not heat the room.
-
Freeze prevention
In this mode, the appliance keeps the room at a
temperature of 7°C to avoid freezing.
-
Heating
In this mode, the desired temperature can be selected
by pressing the adjustment b and – (
B
):
-
Heating
