22
19.1 Installing the filter
1. Press the settings menu (B6);
2. Select "Water filter";
3. Press "OK" to enter the guided procedure
4. Remove the filter from the packaging and turn the date
indicator to view the next two months (fig. 50);
50
51
Please note:
The filter lasts about two months if the appliance is used normal-
ly. If the coffee maker is left unused with the filter installed, it will
last a maximum of three weeks.
5. Press "Next" to continue ("Back" to go back to the previous
screen; "Cancel" to cancel the operation);
6. To activate the filter, run tap water through the hole in the
centre of the filter (fig. 51) until it comes out of the open-
ings at the side for more than a minute. Press "Next";
7. Extract the water tank (A20) (fig. 3) and fill with water; in-
sert the filter in the water tank and immerse it completely
for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 52). Press "Next";
53
52
8. Insert the filter in the filter housing (fig. 53) and press as far
as it will go; press "Next";
9. Close the tank with the lid (A19), then put the tank back in
the machine (fig. 5).
10. Insert the descaling spout (C7). Press "Next";
11. Position an empty container with a minimum capacity of
0.5 litres under the descaling spout (fig. 8) and press "OK"
to activate the filter;
12. The appliance delivers hot water, then stops automatically.
Press "OK" to go back to the homepage (B);
13. The filter is now active and you can use the coffee machine.
19.2 Replacing the filter
Replace the filter (C7) when the corresponding message appears
on the display (B5). To replace the filter immediately, press "OK"
and follow the instructions from point 4. To replace the filter
later, press "Cancel". The symbol (B9) appears on the display to
remind you that the filter needs replacing.
To replace, proceed as follows:
1. Press the settings menu (B6);
2. Select "Replace water filter" and press "Next";
3. Press "OK" to enter the guided procedure;
4. Extract the water tank (A20) and exhausted filter. Press
"Next" to continue ("Back" to go back to the previous
screen; "Cancel" to cancel the operation);
5. Follow the operations described in the previous section
from point (4).
Please note:
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.
19.3 Removing the filter
If you want to use the appliance without the filter (C7), you must re-
move it and notify the appliance of its removal. Proceed as follows:
1. Press the settings menu (B6);
2. Select "Remove water filter" and press "Next";
3. Extract the water tank (A20) and exhausted filter. Put the
tank back in the appliance (fig. 6);
4. Press "OK" to confirm removal of the filter;
5. The change has been saved. Press "OK" to go back to the
homepage (B).
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.
20. TECHNICAL DATA
Voltage:
220-240 V~ 50-60 Hz max. 10 A
Power:
1450 W
Pressure:
1.9 MPa (19 bars)
Water tank capacity:
2.2 l
Size LxDxH:
262x485x390 mm
Cord length:
1750 mm
Weight (dependng on models):
13 / 12,2 kg
52
