6
en
Installation/Instructions
EXHAUSTING HOT AIR
In the Cool Mode the appliance must be placed close to
a window or opening so that the warm exhaust air can be
ducted outside.
First position unit on a flat floor and make sure there's a
minimum of 18” (45 cm) clearance around the unit, and is
within the vicinity of a single circuit outlet power source.
1.
Extend either side of the hose (Fig.
1
) and screw the
hose inlet (Fig.
2
).
2.
Extend the other side of the hose and screw it to the
hose outlet (Fig.
3
).
3.
Install the hose inlet into the unit (Fig.
4
).
4.
Affix the hose outlet into the window slider kit and seal.
(Fig.
5
&
6
).
Your window slider kit has been designed to fit most standard
vertical and horizontal window applications, however, it
may be necessary for you to modify some aspects of the
installation procedures for certain types of windows. The
window slider kit can be fastened with screws.
Please note:
If the window opening is less than
the minimum length of the window slider kit, cut the end
without the hold in it short enough to fit in the window
opening. Never cut out the hole in window slider kit.
WINDOW SLIDER KIT
INSTALLATION
1. Parts:
A)
Panel
B)
Panel with one hole
C)
Additional slider for the 3 panels assembly kit
D)
Screw to lock window kit in place
1
5
6
2
3
4
