19
FLASHING
The coffee beans have run out.
Fill beans container.
The pre-ground coffee funnel (A6)
is clogged.
Empty the funnel with the help of a brush as
described in the section "14.8. Cleaning the
pre-ground coffee funnel".
FLASHING
The infuser has not been replaced
after cleaning (A11).
Insert the infuser as described in the section
“14.9. Cleaning the infuser".
The inside of the appliance is very
dirty.
Clean the inside of the appliance thoroughly,
as described in the section "14. Cleaning". If
the message is still displayed after cleaning,
contact a service centre.
20. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
POSSIBLE CAUSE
REMEDY
The coffee is not hot.
The cups were not preheated.
Warm the cups by rinsing them with hot water.
Please note: the hot water or rinse function can
be used.
The infuser has cooled down because 2/3
minutes have elapsed since the last coffee was
made.
Before making coffee, heat up the infuser by
pressing the
rinse button.
The coffee is weak or not
creamy enough.
The coffee is ground too coarsely.
Turn the grinding dial one click anticlockwise
while the grinder is in operation (fig. 8). Con-
tinue one click at a time until coffee delivery is
satisfactory. The effect is only visible after de-
livering 2 coffees (see section "11.3Adjusting
the coffee mill").
The coffee is unsuitable.
Use pre-ground coffee for espresso machines.
The coffee is delivered too
slowly or a drop at a time.
The coffee is ground too finely.
Turn the grinding dial one click clockwise
while the grinder is in operation (fig. 8). Con-
tinue one click at a time until coffee delivery is
satisfactory. The effect is only visible after de-
livering 2 coffees (see section "11.3. Adjusting
the coffee mill").
Coffee does not come out of
one or both of the spouts.
The spouts are blocked.
Clean the spouts with a toothpick.
