DeLonghi ICMO210, Instructions For Use Manual

Page: 7 / 81

6
automatically 40 minutes after coffee delivery ends.
To turn the plate off press the button again.
• For a new brewing cycle switch off the appliance pressing
button and restart .
Please note: removing the jug before all the coffee re-
quested has been delivered does not interrupt coffee making,
but merely blocks flow into the jug. If you want to pour out a
little coffee immediately, you should do so as rapidly as possible
in order to avoid the coffee overflowing.
Cleaning and maintenance
Before maintenance or cleaning of the appliance, turn off, un-
plug from the mains socket and allow to cool.
• Do not use solvents or abrasive detergents to clean the cof-
fee maker. Just wipe with a soft damp cloth.
• Never immerse the coffee maker in water. It is an electrical
appliance.
• The water tank filter (B) can be reached through the water
tank lid (E). Clean when necessary.
Descaling
If the water in your area is hard, limescale builds up over time.
These deposits may affect correct operation of the appliance.
You are recommended to descale the coffee maker every 60 cof-
fee making cycles. To descale, always use special commercially
available descaling products for drip coffee makers.
1. Dilute the product in the jug, following the instructions on
the descaler pack;
2. Pour the solution into the water tank;
3. Place the jug on the warming plate;
4. Press the button, percolate the equivalent of one cup
then turn the appliance off;
5. Leave the solution to work for 15 minutes, then repeat op-
erations 4 and 5.
6. Turn the appliance on and deliver the water until the tank
is completely empty.
7. Rinse by operating the appliance with water only at least 3
times (3 complete tanks of water).
Failure to clean as described above invalidates the guarantee.
Troubleshooting
Problem Probable cause Solution
The coffee takes
longer to brew. The coffee maker
needs to be
descaled. Descale the ma-
chine as described
in the section
DESCALING.
The coffee has an
acidic taste. Insufficient
rinsing after
descaling. Rinse the ma-
chine as described
in the section
DESCALING.
use
en