7
Timer function
This function can be activated in two different ways.
Delayed start:
With the appliance on-standby, press the
timer button (F) . The symbol is displayed flashing
together with the hours left before the appliance comes on.
Change the hours using the + and - (C) buttons, then wait
a few seconds for the program to be stored. The display will
return to off and the symbols remains on. When the
programmed time has elapsed, the appliance will come on
with the previous settings.
Delayed stop:
with the appliance on, press the timer button
(F). The symbol is displayed flashing together with
the hours left before the appliance goes on-standby. Change
the hours using the + and - (C) buttons, then wait a few
seconds for the program to be stored. The current settings
and symbol are displayed. At the end of the set time the
appliance switches on-standby automatically. To go back to
operating without the timer, press the timer button twice.
The timer symbol disappears from the display.
Note:
the time is settable from 0.5 to 24 hours.
Changing of the temperature scale
The display can show the temperature in both °F (Fahrenheit)
and °C (Celsius). To select the desired temperature scale,
when the unit is in standby position, press and hold the "+"
key for at least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
MAINTENANCE
Before carrying out any maintenance, unplug the heater from
the mains and wait for it to cool off completely. This heater
requires no particular maintenance. It is sufficient to remove
the dust with a soft, dry cloth. Never use abrasive powders or
solvents. If necessary remove concentrated areas of dirt with
a vacuum cleaner.
TECHNICAL CHARACTERISTICS
Supply voltage
See rating label
Absorbed power
“
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The appliance doesn't work
Be sure it is plugged in and that the
electrical outlet is working
The temperature may be set too low
The Key lock may be activated
Plug into the power outlet
Set the temperature to a higher position
See the section "Key lock"
The display shows a blinking
dot and you could hear a
"beep"
The appliance could be tipped over or is
positioned in an improper way
Make sure the appliance is standing upright
on a flat surface. Position the appliance
correctly
The display shows "
PF
"
The temperature sensor is malfunctioning
Contact the De' Longhi costumer experience.
The display shows "
H
t
"
blinking
The internal temperature is too high.
Remove the plug from the mains. Check the
appliance is not covered or obstructed. In
case remove the obstructions.
Check the appliance is correctly positioned
respecting the minimum distance from
the wall, or objects, as indicated on the
instruction manual, if not, position the
appliance correctly. Let the appliance cool
down and plug the appliance again. If it
doesn't work, please contact the De' Longhi
Costumer Experience.
