19
• Empty the collection container and put it back under the hot water spout.
• Press the
OK
button. Hot water is delivered from the spout into the container below and the appliance displays:
RINSING
• When the water tank is empty, the appliance displays the message:
RINSING COMPLETE PRESS OK
• Press the
OK
button and refill the water tank with clean water.
• The descale program is now terminated and the appliance is ready to make coffee again.
NOTE:
If the descaling cycle is interrupted before completion, the appliance continues to display the descale
message and the program must be started again from the beginning.
IMPORTANT:
FAILURE TO DESCALE THE APPLIANCE REGULARLY INVALIDATES THE WARRANTY.
16.4 Changing coffee temperature
To change the temperature of the coffee, proceed as follows:
• Press the button (the light over the button comes on) then press the button repeatedly until
the appliance displays:
TEMP. EXTRA HOT
• Press the button until the appliance displays the required coffee temperature.
• Press the button to confirm the temperature selected;
• Press the button to exit programming mode or to change other parameters.
16.5 Changing the length of time the appliance remains on
The appliance is factory preset to go off automatically one hour after the last coffee has been made.
The number of hours the appliance remains on (max. 3) can be increased as follows:
• Press the button (the light over the button comes on) then press the button repeatedly until the
appliance displays: OFF AFTER 1 HOUR.
• Press the button to change the number of hours the appliance remains on.
• Press the button to confirm the value;
• Press the button to exit programming mode or to change other parameters.
16.6 Setting water hardness
The descale message is displayed after the appliance has been operated for a factory set period of time cal-
culated on the basis of the maximum quantity of lime scale which may be contained in the water used.
If necessary, this period of operation can be extended, making descaling less frequent, by programming the
appliance based on the actual lime content in the water used.
Proceed as follows:
• remove the "Total Hardness Test" strip (enclosed on page 2) from its packaging then dip it fully in the
water for a few seconds. Remove it and wait around 30 seconds (until it changes color and a number of
squares are formed);
• Turn the appliance on by pressing the button (fig. 6).
• Press the button (the light over the button comes on) then press the button repeatedly until
the appliance displays:
WATER HARDNESS 4
• Press the button repeatedly until the number coincides with the number of squares on the test
strip (for example, if there are 3 squares on the test strip, press the button until WATER HARDNESS 3 is
displayed).
• Press the button to confirm the value. The coffee maker is now programmed to provide the desca-
ling warning when necessary, based on the actual hardness of the water.
