14
11 CHANGING THE QUANTITY OF HOT WATER
The appliance is factory preset to automatically deliver 8.5 oz of hot water.
To change these quantities, proceed as follows:
• Attach the water spout (fig. 4).
• Position a container under the spout (fig. 3).
• Press the button for at least 8 seconds then release. The appliance displays:
HOT WATER PROGRAM QUANTITY
and hot water is delivered from the water spout.
• When the hot water in the cup reaches the required level, press the button to memorize the new
amount. (You should not run off hot water for more than two minutes at a time).
12 PREPARING CAPPUCCINOS OR LATTE (MILK WITH COFFEE )
• Select the taste of the coffee you want to use to make the cappuccino by pressing the button.
• Remove the frothed milk lid from the milk container.
• Fill the container with about 3.5 ounces of milk for each cappuccino to be prepared (fig. 19).
Never
exceed the MAX level (corresponding to about 25 oz) marked on the container.
You are recommended
to use skim or 2% milk at refrigerator temperature (about 41°F/5° C).
• If you want to make cappuccino (frothed milk + coffee), put the lid with the wording "FROTHED MILK -
CAPPUCCINO” on the milk container. If, on the other hand, you want to prepare hot milk with coffee,
put the lid with the wording "STEAMED MILK – LATTE” on the milk container.
• Make sure the milk intake tube is correctly inserted in the rubber washer (fig. 20) and that the frothed
milk spout is moved outwards as shown in fig. 23.
• Remove the hot water spout (fig. 21) and attach the milk container to the nozzle, making sure the arrow on the
container lid is lined up with the arrow on the control panel of the appliance (fig. 22).
• Position the milk tube as shown in fig. 23 and then place a sufficiently large cup under the coffee and
milk spouts (fig. 23).
• Press the button (fig. 24). The appliance displays:
CAPPUCCINO OR LATTE
and after a few seconds, the frothed milk is delivered from the milk spout into the cup below. (Delivery
stops automatically).
• The appliance then grinds the beans, delivers the coffee and displays the "ready" message again.
• The cappuccino is ready. Sweeten to taste and, if desired, sprinkle the froth with a little cocoa powder.
NOTE 1:
While preparing the cappuccino, milk or coffee delivery can be interrupted by pressing button .
NOTE 2:
If you run out of milk while delivering the milk, remove the container and refill it. Then put it back
in place and press the button to request a cappuccino again.
NOTE 3:
To ensure the milk frother is absolutely clean and hygienic, after making cappuccinos, clean the
channels inside the milk container lid:
• Place a cup under the milk spout;
• Press the button on the frothed milk container lid and hold down for at least 8 seconds (fig. 25).
The appliance displays:
CLEANING
After cleaning is complete, remove the milk container and place in the refrigerator. You should not leave
the milk outside the refrigerator for more than 15 minutes.
