DeLonghi ESAM22 Series, Instructions For Use Manual

Page: 11 / 20

10
with a minimum capacity of 100 ml underneath (fig. 2).
3. Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(fig. 3).
4. IMMEDIATELY AFTERWARDS (WITHIN A MAXIMUM OF 30
SECONDS), turn the steam knob anticlockwise as far as it
will go (fig. 5). This is priming the water system. (It is nor-
mal for the machine to make some noise).
5. Wait for delivery of hot water to stop automatically. The
lights flash to indicate that you must close the steam tap
by turning the steam knob to the 0 position.
6. Turn the steam knob to the 0 position. The appliance goes
off automatically.
To use the appliance, turn it on.
Please note:
• When using the appliance for the first time, you need to
make 4-5 cups of coffee or 4-5 cappuccinos before the ap-
pliance starts to give satisfactory results.
TURNING THE APPLIANCE ON
Please note:
Before turning the appliance on, make sure the main switch on
the back of the appliance is in the
I position (fig. 3).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
• To turn the appliance on, press the button (fig. 4).
The and lights flash while the appliance is
heating up and performing an automatic rinse cycle. By cir-
culating the hot water, the appliance heats both the boiler
and the internal circuits. During this phase, the
light
flashes.
When the and lights remain on steadily, the
appliance is at temperature.
TURNING THE APPLIANCE OFF
Each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the button (fig. 4). The
appliance performs a rinse cycle.
Please note:
If the appliance is not used for an extended period, place the main
switch in the 0 position (fig. 6).
Important!
To avoid damaging the appliance, never place the main switch
(fig. 6) in the 0 position while the appliance is on.
SETTING AUTO-OFF (STAND BY)
Auto-off can be changed so that the appliance goes off after 15
or 30 minutes, or after 1, 2 or 3 hours.
1. Press and hold the ECO button until the 5 lights at the back
of the control panel come on.
2. Select the required period of time (15 or 30 minutes or 1,
2 or 3 hours) by pressing the button (see the light/
time table).
15min 30min 1h 2h 3h
.
3. Press the ECO button to confirm the selection and return to
normal use of the appliance.
Auto-off is programmed.
Please note:
To disconnect the appliance completely, place the main switch
at the back of the appliance in the 0 position (fig. 6).
ENERGY SAVING
Energy saving mode reduces energy consumption in compliance
with current European regulations.
To activate or deactivate this mode, press the
ECO
button. After
a period of inactivity, if ECO mode is active the
ECO
button light
comes on.
This mode is active by default.
Please note:
A few seconds may elapse between energy saving mode and
delivery of the first coffee.
MAKING COFFEE
Selecting the coffee taste
Turn the knob to select the required taste. Turning it clockwise
increases the quantity of coffee beans the appliance will grind
and therefore the strength of the coffee obtained.