6
134
Ø 5,25 in
3
in the wooden
ic board of a French
window or panel
in the wall:
you are
recommended to insulate
the section of wall using
suitable insulation
• Fit the wall flange
B1
into the hole.
• Fit the hose
B2
into the wall flange
B1
as shown in fig. 4.
• When the hose
B2
is not connected, the drilled hole can be
closed with the flange cap
B1
.
4
max 39 in
max 100 cm
min 14 in
min 35 cm
• When installing the air conditioner, you should leave a door
slightly open little as 1/2“ (1 cm) to guarantee correct
ventilation and room pressure.
• Keep the air hoses as short and free of curves as possible to
avoid constrictions.
Note:
•
As special tools are required for this type of
installation, we suggest you have the appliance in-
stalled by specialized personnel.
AIR CONDITIONING WITHOUT INSTALLATION
You can also set-up in a double-hung window:
• Place the window brac et in the window sill, extend the
brac et fully within the window frame, fix the brac et by
using the pin then lower the window onto the brac et.
(Should the window brac et be too large for the window,
the plastic can be cut with a saw by a qualified profes-
sional.)
• Fit the air exhaust hose
B2
in the relevant housing located
on the rear side of the appliance. (fig. 1).
• Connect the window outlet
B3
to the other end of the ex-
haust hose.
• Insert the window outlet
B3
of the exhaust hose into the
slot of the window brac et (fig. 5).
5
Other set-up methods:
• Than s to the loc ing pins, it’s possible to use the window
brac et also for sliding windows. Position the hole of the
brac et so to allow a correct installation of the exhaust hose
(see figure 6).
6
