15
TROUBLESHOOTING
Chec the following points before calling the authorised Technical Service Centre in your area.
PROBLEMS
CAUSES
SOLUTIONS
The air conditioner does not turn on
lt is not plugged in
plug it in
there is no power
wait
the internal protection device was triggered call the help centre
The air conditioner wor s for a short
period of time
the air exhaust hose is obstructed or bent correctly position the air exhaust hose,
limiting the length and curves as much
as possible and avoiding any obstructions
an obstruction is impeding air exhaust
outside
identify and remove the obstacles that
impede air exhaust outside
The air conditioner runs but does not cool
the room
windows, doors, drapes open
close the windows, doors and drapes,
eeping in mind the “recommendations
for proper use”
there is some heat source in the room
(oven, hair dryer, etc.)
eliminate the heat source
the air exhaust hose is disconnected from
the appliance
attach the air exhaust hose to the housing
on the bac of the appliance (fig.1)
dust filters clogged
clean or replace the filters as previously
described
the technical characteristics of the
appliance are not suitable for cooling the
room where it is located
During operation there is an unpleasant
odour in the room
dust filters clogged
clean or replace the filters as previously
described
The air conditioner does not wor for
about 3 minutes from restart
to protect the compressor there is an
internal device that delays startup for
about 3 minutes from restart
wait;
The display shows the
symbol with
one of the following messages:
HL/PF
the appliance has a self-diagnosis system
that identifies some operating errors
refer to the SELF-DIAGNOSIS chapter
