DeLonghi ECAM44.66X ELETTA, Instructions For Use Manual

Page: 21 / 23

20
The appliance complies with the following EC
directives:
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent amendments;
• European Stand-by Regulation 1275/2008;
• Materials and accessories coming into contact with food
conform to EC regulation 1935/2004.
DISPOSAL
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK Insufficient water in the tank (A16). Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
EMPTY GROUNDS CONTAINER The grounds container (A10) is full. Empty the grounds container and drip tray,
clean and replace.
Important: when removing the drip tray, the
grounds container MUST be emptied, even if it
contains few grounds.
If this is not done, when you make the next
coffees, the grounds container may fill up more
than expected and clog the machine.
GROUND TOO FINE ADJUST
MILL The grinding is too fine and the coffee is delive-
red too slowly or not at all. Repeat coffee delivery and turn the grinding
adjustment dial (fig. 13) one click clockwise to-
wards “7” while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see the section:
“Adjusting the coffee mill on page12).
INSERT GROUNDS CONTAINER After cleaning, the grounds container (A10) has
not been replaced.
Remove the drip tray and insert the grounds
container.
ADD PRE-GROUND COFFEE With the “pre-ground coffee” function selected,
pre-ground coffee has not been poured into the
funnel (A4). Place pre-ground coffee in the funnel (fig. 17)
or deselect the “pre-ground” function.
DESCALE The machine must be descaled. The descaling procedure described in the sec-
tion “Descaling” needs to be performed as soon
as possible (page 17).
LESS COFFEE Too much coffee has been used.
Select a milder taste by pressing the
button (fig. 10) or reduce the quantity of pre-
ground coffee.