20
DISPLAYED MESSAGES
DISPLAYED MESSAGE
POSSIBLE CAUSE
REMEDY
FILL TANK !
•
Insuficient water in the tank.
•
Fill the tank with water and/or insert it
correctly, pushing it as far as it will go
until it clicks into place (fig. 3).
EMPTY GROUNDS
CONTAINER
•
The grounds container (A13) is full.
•
Empty the grounds container and
drip tray, clean and replace (fig. 23).
Important: when removing the drip
tray, the grounds container MUST be
emptied, even if it contains few grounds.
If this is not done, when you make the
next coffees, the grounds container may
fill up more than expected and clog the
machine.
GROUND TOO FINE
ADJUST MILL!
alternating with...
TURN STEAM KNOB
•
The grinding is too ine and the coffee is
delivered too slowly or not at all.
•
Repeat coffee delivery and turn the
grinding adjustment knob one click
clockwise towards “7” while the coffee
mill is in operation. If after making at
least 2 coffees delivery is still too slow,
repeat the correction procedure, turning
the grinding adjustment knob another
click (see the section “Adjusting the
coffee mill” on page 12). If the problem
persists, turn the steam knob to the
I position and deliver water from the
cappuccino maker.
INSERT GROUNDS
CONTAINER
•
After cleaning, the grounds container
has not been replaced.
•
Remove the drip tray and insert the
grounds container.
ADD PRE-GROUND
COFFEE
•
The “pre-ground coffee” function has
been selected without placing any pre-
ground coffee in the funnel.
•
Place pre-ground coffee in the funnel or
deselect the “pre-ground” function.
DESCALE!
•
The machine must be descaled.
•
The descaling procedure described in
the “Descaling” section needs to be
performed as soon as possible.
LESS COFFEE!
•
Too much coffee has been used.
•
Select a milder taste or reduce the
quantity of pre-ground coffee.
FILL BEANS
CONTAINER!
•
The coffee beans have run out.
•
Fill the beans container
•
The pre-ground coffee funnel is clogged.
•
Empty the funnel with the help of a brush
as described in the section “Cleaning the
pre-ground coffee funnel”.
INSERT INFUSER
ASSEMBLY!
•
The infuser has not been replaced after
cleaning.
•
Insert the infuser as described in the
section “Cleaning the infuser”.
INSERT TANK
•
The tank is not correctly in place.
•
Insert the tank correctly and press as far
as it will go.
GENERAL ALARM!
•
The inside of the appliance is very dirty.
•
Clean the inside of the appliance
thoroughly, as described in the section
“Cleaning and maintenance”. If the
message is still displayed after cleaning,
contact a customer services.
