18
20.1 Installing the filter
1. Remove the filter (C4) from the packaging. The date indica-
tor disk varies according to the filter provided (fig. 28);
2. Turn the date disk to display the next 2 months of use.
Please note
The filter lasts about two months if the machine is used normal-
ly. If the coffee machine is left unused with the filter installed, it
will last a maximum of 3 weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in fig. 29until water comes out of the open-
ings at the side for more than a minute;
4. Extract the tank (A17) from the machine and fill with
water;
5. Insert the filter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 30).
6. Insert the filter in the filter housing (A18) and press as far
as it will go (fig.31);
7. Close the tank with the lid (A16 - fig. 32), then replace the
tank in the machine;
8. Position a container with a minimum capacity of 16.90 floz
/ 500ml under the frother (A20).
9. Deliver hot water by turning the steam/hot water dial
(A22) to the
I
position.
10.
Deliver at least 16.90 floz / 500 ml of hot water, then
turn the steam/hot water dial
to the
O
position.
The filter is now active and you can use the coffee machine.
20.2 Replacing the filter
After two months (see date indicator) or when the machine has
not been used for 3 weeks, you should replace the filter:
1. Extract the tank (A17) and exhausted filter (C4);
2. Take the new filter out of its packet and proceed as de-
scribed in points 2 to 10 in the previous section.
The new filter is now active and you can use the coffee machine.
21. TECHNICAL DATA
Voltage:
120 V~ 60 Hz
Absorbed power:
1250 W
Pressure:
1.5MPa (15 bars)
Max. water tank capacity:
60.86 fl oz (1.8 L)
Size LxDxH: 9.45x17.32 x 14.17in. (240x440x360 mm)
Cord length:
45.27 in (1150 mm)
Weight:
20 lb (9.2 kg)
Max. beans container capacity:
10.58 oz (300 g)
