8
INSTALLATION
CAUTION:
■
This appliance must be installed in accordance with these installation instructions.
■
This appliance shall only be serviced by authorised personnel.
■
This appliance is to be installed only by an authorised person in compliance
with the current electrical regulations and in observation of the instructions
supplied by the manufacturer.
Failure to comply with this condition will render the guarantee invalid.
■
Incorrect installation, for which the manufacturer accepts no responsibility, may
cause personal injury of damage.
■
Always disconnect the appliance from mains power supply before carrying out
any maintenance operations or repairs.
ELECTRICAL REQUIREMENTS
■
Connection to the mains must be carried out by qualified personnel in accordance with
current regulations.
■
The appliance must be connected to the mains checking that the voltage corresponds
to the value given in the rating plate and that the electrical cable sections can withstand
the load specified on the plate.
■
A suitable isolating switch providing full disconnection from the mains power supply
shall be incorporated in the permanent wiring, mounted and positioned to comply with
the local wiring rules and regulations. The isolating switch must be of an approved
type and provide a 3 mm air gap contact separation in all poles (or in all active [phase]
conductors if the local wiring rules allow for this variation of the requirements).
■
The isolating switch shall be easily accessible to the customer with the oven installed.
■
The power supply cable must not touch the hot parts and must be positioned so that it
does not exceed 75°C above ambient.
■
Once the appliance has been installed, the switch or socket must always be accessible.
■
If the supply cord is damaged it must be replaced by the manufacturer or it’s Service
Agent or a similarly qualified person in order to avoid a hazard.
N.B. The connection of the appliance to earth is mandatory.
For connection to the mains, do not use adapters, reducers or branching devices as
they can cause overheating and burning.
If the installation requires alterations to the domestic electrical system call a qualified
electrician. He should also check that the domestic electrical system is suitable for the
power drawn by the appliance.
Replacing the power cord must be done by a qualified electrician in accordance with
the instructions supplied by the manufacturer and in compliance with established
electrical regulations.
Summary of Contents for DEP909P
Page 2: ...2 ...
