24
S e l e c t i n g t h e f u n c t i o n s
6) Press the “
power level
” button to select the desired dehumidifi heating power level
(MIN/MAX).
7) Press the “ ” button to display, in sequence, the ambient relative humidity (“ ” indi-
cator light flashing) and the ambient temperature (“ ” indicator light flashing).
8) When the appliance reaches the humidity set point, it will stop and the periodical ventila-
tion function will start, so as to ensure a correct humidity reading. As soon as the humidity
increases above the set point, the appliance will automatically resume dehumidification
plus heating operation.
T
urbo power
1) Plug the appliance into a power socket.
2) The display shows “- -“ to indicate that the appliance is in standby and therefore ready for
operation. If the message “FT” is displayed, empty the tank or position it correctly.
3) Press the button.
4) The turbo power function is an automatic dehumidifi heating function that is used
when wanting to operate the appliance at maximum power. In this mode, the humidity
and temperature set points are deactivated. In any case, a maximum temperature pro-
tection device stops the heating function in the event of excess temperature, while still gua-
ranteeing the dehumidification function. The appliance resumes heating operation as soon
as the temperature falls back below the maximum value. The display shows the message
“t P”. Neither the humidity or temperature set point nor the power level can be changed.
To deactivate the turbo power function, simply press the button again.
H
ow to program the delayed start function
•
Plug the appliance into a power socket and press the ON/OFF button; then select the desi-
red function and power level.
•
Press the ON/OFF button again: the appliance will go into Standby mode.
•
Press the timer button: the two centre segments “- -“ will flash on the display.
•
Use the + or - button to set the number of hours after which the appliance should start ope-
ration. The timer indicator light comes on. The appliance can be set to start in the following
24 hours.
H
ow to program the delayed stop function
•
The delayed stop function can be set in any operating mode (dehumidification/hea-
ting/combi/turbo power).
•
Press the timer button: the two centre segments “- -“ will flash on the display.
•
Use the + or - button to set the number of hours after which the appliance should stop ope-
ration.
The timer indicator light comes on. At the pre-set time, the appliance will stop and go into
Standby mode.
5748011200DE350E/GB 21-01-2004 10:49 Pagina 24
