GB
24
adding salt
If the water in your area is hard, deposits will form on your dishes and utensils. This appliance
contains a salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir and it must be set to correspond
to the water hardness level in your area.
1. Remove the basket and unscrew the reservoir cap.
2. Fill the reservoir with approximately 500ml of water (first
use only).
3. Place the funnel provided over the salt reservoir.
4. Pour in approximately 1.5 kg of dishwasher salt
depending on the brand used.
5. Clean any excess salt from around the reservoir opening
and then screw the cap on again firmly.
6. Run a short wash programme immediately (without any
crockery in the dishwasher) to remove any traces of salt
from the compartment.
• Salt refill indicator will illuminate when the
reservoir is running out of salt and requires
refilling.
• The salt refill indicator will cease to
illuminate within a few days, depending on
how quickly the salt dissolves.
• If you decide to use a detergent tablet, you
may not need to add salt, this depends
upon the water hardness in your area and
the type of tablet being used. Check with
your water supplier and the detergent tablet
manufacturer’s instructions.
open
open
open
DDWTT17-TTS19_IB_2L_190619_grace.indb 24
19/6/2019 4:58 PM