DELLA 048-GM-48200, User Manual

Page: 7 / 15

7
it from being exposed in the sunlight.
●
The appliance must be positioned so that the plug is accessible.
z
Fasten the drain cap tightly at the back of the unit before start to run the unit. Because during
the shipping process, it maybe has loosed. When you not fasten it again, it will cause the
water leakage and make your floor wet.
z
Do not plug the power cord into the power socket yet! Read the instructions first.
This unit is for indoor use only.
Room temperature should not exceed 97F/36C
CLEAN YOUR UNIT BEFORE FIRST USING
Before using your unit, it is strongly recommended to clean it thoroughly.
1. Take out the accessory- Ice shovel from ice-making chamber.
2. The outside of the unit should be cleaned regularly with a mild detergent solution and warm
water.
3. For the first time, hold the clean water bottle vertically and upside down (over the smart
device) and place the water bottle into the smart device receptacle. After some minutes, the
water will flow into all of the faucets, the cold water tank and hot water tank, till the water can
flow out from the faucet. Then take down the water bottle, and open the drain cap for the hot
tank, let all of the water flow out, then reinstall back the drain cap and tighten it.
4. Clean the ice-making chamber with diluted detergent, warm water and a soft cloth, then use
the water to rinse the inside parts, and drain out the water by unplugging the drain cap of the
ice dispenser on the down back of the unit. Then also reinstall back this drain cap of ice
dispenser and tighten it.
5.
When the machine is not in use for a long time, open both of the water drained cap to drain
water completely from unit.
PREPARE FOR USE
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged please call our customer service.
1).Make sure that the unit is not plugged into the main electrical outlet.
2).Before placing drinkable water bottle on the unit, be sure that the drain cap on the back is
tightly fastened.
3). Hold the water bottle vertically and upside down (over the smart device) and place the water
bottle into the smart device receptacle. Apply slightly pressure in order to pierce the bottle cap
with the spigot. This unit accepts two, three or five gallons water bottle with pierceable sealed
caps.
4). Open the water faucet to let the air out, until the water starts to flow out. When this happens,
release the faucet taps.