Dell XPS M1210, Owner'S Manual, Page: 95 / 192

Troubleshooting
95
T IME - OF - DAY NOT SET - PLEASE RUN THE SYSTEM SETUP PROGRAM —
The time or date stored in the system
setup program does not match the system clock. Correct the settings for the Date and Time options. See
"Using the System Setup Program" on page 171 .
T IMER CHIP COUNTER 2 FAILED —
A chip on the system board may be malfunctioning. Run the System
Set tests in the Dell Diagnostics (see page 85).
U
NEXPECTED INTERRUPT IN PROTECTED MODE
—
The keyboard controller may be malfunctioning, or a
memory module may be loose. Run the System Memory tests and the Keyboard Controller test in the
Dell Diagnostics (see page 85).
X : \ IS NOT ACCESSIBLE . T HE DEVICE IS NOT READY —
Insert a disk into the drive and try again.
W ARNING : B ATTERY IS CRITICALLY LOW —
The battery is running out of charge. Replace the battery, or
connect the computer to an electrical outlet. Otherwise, activate hibernate mode or shut down the
computer.
ExpressCard Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide .
C
HECK THE
E
XPRESS
C
ARD
—
Ensure that the ExpressCard is properly inserted into the connector.
E
NSURE THAT THE CARD IS RECOGNIZED BY
W
INDOWS
—
Double-click the Safely Remove Hardware icon in
the Windows taskbar. Ensure that the card is listed.
I F YOU HAVE PROBLEMS WITH A D ELL - PROVIDED E XPRESS C ARD —
Contact Dell. See "Contacting Dell" on
page 141. Also, for Mobile Broadband (WWAN) ExpressCards, see "For information about troubleshooting
wireless local area networks, see "Wireless Local Area Network (WLAN)" on page 76." on page 99.
I
F YOU HAVE PROBLEMS WITH AN
E
XPRESS
C
ARD NOT PROVIDED BY
D
ELL
—
Contact the ExpressCard
manufacturer.
IEEE 1394 Device Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product
Information Guide .
E NSURE THAT THE I E E E 1 3 9 4 DEVICE IS RECOGNIZED BY W INDOWS —
1
Click the Start button and click Control Panel .
2
Click Printers and Other Hardware .
If your IEEE 1394 device is listed, Windows recognizes the device.
I F YOU HAVE PROBLEMS WITH A D ELL - PROVIDED I E E E 1 3 9 4 DEVICE —
Contact Dell or the IEEE 1394
device manufacturer. See "Contacting Dell" on page 141.
I F YOU HAVE PROBLEMS WITH AN I E E E 1 3 9 4 DEVICE NOT PROVIDED BY D ELL —
Contact Dell or the IEEE
1394 device manufacturer. See "Contacting Dell" on page 141.
E NSURE THAT THE I E E E 1 3 9 4 DEVICE IS PROPERLY INSERTED INTO THE CONNECTOR