Installing The Display Assembly
1. Align the display assembly to the computer base.
2. Tighten the screw to secure the right hinge in place.
3. Tighten the screws to secure the display assembly to the bottom base
chassis.
4. Connect the display cable to the connector on the system board.
5. Route the WLAN and WWAN antenna cables along their routing channels
and connect them to their respective modules.
6. Install the
palm rest
.
7. Install the
hard drive
.
8. Install the
keyboard
.
9. Install the
base cover
.
10. Install the
battery
.
11. Follow the procedures in
After Working Inside Your Computer
.
35
Summary of Contents for VOSTRO P18S
