Replacing the solid-state drive
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at
CAUTION:
Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Topics:
•
•
Procedure
1
Align the notches on the solid-state drive with the tabs in the solid-state drive slot, slide the solid-state drive at an angle into the solid-
state drive slot, then press the other end of the solid-state drive down.
2
Align the screw holes on the hard disk plate with the screw holes on the system board.
3
Replace the two screws (M1.6x2.5) that secure the hard-disk plate to the system board.
4
Adhere the display-cable tape to the hard-disk plate.
Post-requisites
1
Replace the
.
2
Replace the
.
8
16
Replacing the solid-state drive
Summary of Contents for Studio XPS 13 - Laptop - Obsidian
Page 10: ...10 Removing the base cover ...
Page 13: ...Removing the battery 13 ...
Page 18: ...18 Disconnecting the wireless antenna cables ...
