Back to Contents Page
Support Assembly
Dell Studio One 19/1909 Service Manual
Removing the Support Assembly
Replacing the Support Assembly
Removing the Support Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the hard drive (see
Removing the Hard Drive
).
3.
Remove the power supply unit (see
Removing the Power Supply Unit
).
4.
Remove the optical drive (see
Removing the Optical Drive
).
5.
Remove the side I/O panel (see
Removing the Side I/O Panel
).
6.
Remove the inverter (see
Removing the Inverter
).
7.
Remove the system board (see
Removing the System Board
).
8.
Remove the fourteen screws that secure the support assembly to the LCD panel.
9.
Disconnect the following cables from the LCD panel:
l
LVDS cable from LVDS connector
l
touch pad cable from the touch pad connector
l
touch panel cable from the touch panel module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as the computer stand).
1
screws (14)
2
support assembly
Summary of Contents for Studio One 19
Page 10: ...Back to Contents Page ...
Page 25: ...10 Check the amount of memory RAM listed Back to Contents Page ...
Page 39: ......
