Dell SonicWALL SRA 4200/1200 Getting Started Guide
52
Dell SonicWALL SRA 1200/4200 Appliance
Regulatory Statement and Safety Instructions
The most up-to-date regulatory information can be found in the Dell
SonicWALL SRA Regulatory Statement online version located on:
http://www.sonicwall.com/us/support/3893.html
.
•
The above Dell SonicWALL appliances are designed to be
mounted in a standard 19-inch rack mount cabinet. The following
conditions are required for proper installation:
•
Use the mounting hardware recommended by the rack
manufacturer and ensure that the rack is adequate for the
application.
•
Four mounting screws, compatible with the rack design, must be
used and hand tightened to ensure secure installation. Choose a
mounting location where all four mounting holes line up with those
of the mounting bars of the 19-inch rack mount cabinet.
•
Mount in a location away from direct sunlight and sources of heat.
A maximum ambient temperature of 104º F (40º C).
•
Route cables away from power lines, fluorescent lighting fixtures,
and sources of noise such as radios, transmitters and broadband
amplifiers.
•
The included power cord(s) are approved for use only in specific
countries or locations. Before using a power cord, verify that it is
rated and approved for use in your location.
•
Allow unrestricted airflow around the unit and through the side
vents. A minimum of 1 inch (25.44mm) clearance is recommended.
•
Mount the SRA appliances evenly in the rack to prevent a
hazardous condition caused by uneven mechanical loading.
•
If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than
room ambient temperature. Therefore, consider installing the
equipment in an environment compatible with the maximum
recommended ambient temperature shown above.
•
Consideration must be given to the connection of the equipment to
the supply circuit. The effect of overloading the circuits has minimal
impact on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings must be used when
addressing this concern.
•
Reliable grounding of rack-mounted equipment must be
maintained. Particular attention must be given to power supply
connections other than direct connections to the branch circuits
such as power strips.
Lithium Battery Warning
The Lithium Battery used in the Dell SonicWALL Internet security
appliance may not be replaced by the user. The Dell SonicWALL must
be returned to a Dell SonicWALL authorized service center for
replacement with the same or equivalent type recommended by the
manufacturer. If, for any reason, the battery or Dell SonicWALL Internet
security appliance must be disposed of, do so following the battery
manufacturer's instructions.
Cable Connections
All Ethernet and RS232 (Console) cables are designed for intra-building
connection to other equipment. Do not connect these ports directly to
communication wiring or other wiring that exits the building where the
Dell SonicWALL is located.
Regulatory Model/Type
Product Name
1RK23-0A0
1RK23-0A1
Dell SonicWALL SRA1200
Dell SonicWALL SRA4200