Dell S6100, Configuration Manual

Page: 284 / 1743

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands
• set automatic-tag — compute the tag value of the route.
• set level — specify the OSPF area for route redistribution.
• set metric — specify the metric value assigned to redistributed routes.
• set metric-type — specify the route type assigned to redistributed routes.
set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
Syntax set weight weight
To delete a weight specification, use the
no set weight weight
command.
Parameters
weight Enter a number as the weight used by the route meeting the route map specification. The
range is from 0 to 65535. The default is router-originated =
32768 and all other routes =
0 .
When there are multiple routes to the same destination, the routes with a higher weight
are preferred.
Defaults router-originated = 32768 ; all other routes = 0
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
284 Access Control Lists (ACL)