Dell S6100, Configuration Manual

Page: 280 / 1743

To delete a setting, enter
no set metric
.
Parameters
+ (OPTIONAL) Enter + to add a metric-value to the redistributed routes.
- (OPTIONAL) Enter
-
to subtract a metric-value from the redistributed routes.
metric-value Enter a number as the new metric value. The range is from zero (0) to 4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands
• set automatic-tag — compute the tag value of the route.
• set level — specify the OSPF area for route redistribution.
• set metric-type — specify the route type assigned to redistributed routes.
• set tag — specify the tag assigned to redistributed routes.
set metric-type
To assign a new route type for routes redistributed to OSPF, configure a filter.
Syntax set metric-type {internal | external | type-1 | type-2}
To delete a setting, use the
no set metric-type
command.
280 Access Control Lists (ACL)