4. Disassembly and Assembly Procedures
Tear off all the mylar and tapes, then use a Philips-
head screwdriver to remove 7pcs screws for
releasing the diffuser, reflector and LGP.
Remove the middle bezel and put it into a fixture jip,
then use
a Philips-head screwdriver to remove 1pcs
screw for unlocking the power key board with the
front bezel.
(No.1 Screw size= M2x2.4, Torque=0.8
±0.2
kgfxcm)
S10
1
6
5
4
2
3
7
Tear off the mylar tape on the position as the picture
below shown. Use a Philips-head screwdriver to
remove 13pcs screws for unlocking the middle bezel
with the panel module. Use a Philips-head
screwdriver to remove 2pcs screws for unlocking the
middle bezel with the front bezel.
(No.1~13 Screw size= M3x5, Torque=3~4kgfxcm;
No.14~15 Screw size= M2x2.7,Torque=1~2kgfxcm)
Tear off all the adhesive tapes for releasing the panel
lamp cable, then disconnect the cable away from the
connectors of the power board and panel.
1
Lift up the panel module and pull out the front bezel
for releasing the front bezel.
U
.
se a Philips-head screwdriver to remove 4pcs
screws for locking the bracket chassis module with
the panel
(No.1~4 Screw size= M3x0.5x2.8, Torque=5
~6
kgfxcm)
S11
S12
2
3
4
1
S7
S8
S9
