Figure 82. Installing the heat sink
1.
retention screw slot (4)
2. retention screw (4)
3. heat sink
4. processor shield
Next steps
1.
Follow the procedure listed in the After working inside your system section.
2.
While booting, press F2 to enter System Setup and verify that the processor information matches the
new system configuration.
3.
Run the system diagnostics to verify that the new processor operates correctly.
Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Removing a heat sink
After working inside your system
Redundant AC power supply
Your system supports either:
• Two 495 W, 750 W, or 1100 W (Platinum) AC power supply modules or
• Two 450 W (Bronze) AC power supply modules
NOTE: When two identical PSUs are installed, power supply redundancy (1+1 – with redundancy or
2+0 – without redundancy) is configured in system BIOS. In redundant mode, power is supplied to
the system equally from both PSUs when Hot Spare is disabled. When Hot Spare is enabled, one of
the PSUs will be put into standby when system utilization is low in order to maximize efficiency.
CAUTION: If two power supplies are used, they must be of the same maximum output power.
174
