Figure 92. Removing the VGA module
Next steps
.
Installing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
.
4.
5.
.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
2. Align the hole on the module with the screw hole on the system.
3. Using the Phillips #1 screwdriver, secure the VGA module to the system with the screw.
Installing and removing system components
89
Summary of Contents for PowerEdge R450
Page 15: ...Figure 11 Memory information Dell EMC PowerEdge R450 system overview 15 ...
Page 16: ...Figure 12 Service information electrical overview 16 Dell EMC PowerEdge R450 system overview ...
Page 17: ...Figure 13 Service information mechanical overview Dell EMC PowerEdge R450 system overview 17 ...
